Courses:

Engineering Design and Rapid Prototyping >> Content Detail



Calendar / Schedule



Calendar

L = Lecture


Ses #TOPICSACTIVITIESKEY DATES
1L1: Introduction to Design (de Weck)

L2: Hand Sketching (Wallace)
Form teams, Sketch initial designs by hand, Tour the facilities
2L3: Airfoil Analysis, Xfoil Tutorial (Drela)

L4: CAD Modeling, SolidWorks® Tutorial (de Weck)
Choose initial airfoil, Rough sizing, Hand calculation of lift, drag and mass, Initial design of support structure(A) Hand sketch of conceptual design (1 page)
3L5: Computer Aided Engineering (CAE)-FEM (de Weck)

L6: Design Optimization (de Weck)
Start FEM modeling, Refine loads analysis

Introduction to aero-structural interactions and optimization, Refine initial design
(B) Initial 2-D airfoil design and analysis (2-page memo)
4L7: Guest Lecture: Bill Taylor (ArvinMeritor)

L8: Introduction to CAM (de Weck, Col. Young)
Introduction to water-jet cutter, and foam cutter (Col. Young), Lab work, Start manufacturing(C) Initial 3-D SolidWorks® model (2-page memo)
5L9: Structural Testing (de Weck)Continue building wing, manufacture support structure, perform assembly(D) Final 3-D CAD model, including airfoil and FEM analysis (4-page report)
6L10: Wind Tunnel Testing (Perdichizzi)Structural load test(E) Completed wing assignment (1-page report on manufacturing)
Testing - Wind Tunnel Test
7Preparation for the Final Review(F) Final testing report (2-page report)
8L11: Guest Lectures: Dr. Jaroslaw Sobieski, NASA
Dr. David Chang, GM

Critical Design Review (CDR)
Give final presentations; Announce winner of design competition(G) CDR presentation (max 7 slides), reflective memo (1 page)

 








© 2010-2021 OpenCollege.com, All Rights Reserved.
Open College is a service mark of AmeriCareers LLC.